Capacitance scaling of grain boundaries with colossal permittivity of CaCu3Ti4O12-based materials

Samples of copper-deficient CaCu₃Ti₄O₁₂ (CCTO) compared to the nominal composition, all synthesized via organic gel-assisted citrate process, show huge change of grain boundaries capacitance as deduced from a fit of an RC element model to the impedance spectroscopic data. The grain boundary capacitance is found to scale with the permittivity measured at 1 kHz weighted by the size of the grains. This result is found consistent with the internal barrier layer capacitance (IBLC) model.     

High-efficiency absorption of low NOX concentration in metallurgical flue gas using a three dimensional printed large-flow microstructured reactor

In the process of nitric acid dissolving precious metals, a large amount of NOx exhaust gas will be produced. This research aims at the development of a new method for the removal of low-concentration nitrogen oxides from metallurgical flue gas. In this process, a printed three-dimensional large-flow microstructure reactor and urea solution are used for the removal of NOx, which facilitates the greater efficiency of denitrification(≥94%). Urea plays an important role in the redox of NO₂, such as NO₂ is reduced to N₂ in solution. Both the gas and the liquid phase simultaneously react in the microchannels of the microfluidic reactor. The channels allow the proper mixing of urea and NaClO₂ during the flow which efficiently removes NO_x at low concentrations. The optimum condition for high denitration efficiency is outlined: the urea solution with 3%,temperature of the mixed solution is 293.15 K, gas–liquid flow mass ratio is 1:1, pH value (8.0–10.0), C_NaClO2 = 0.02 mol/L. This work successfully describes the use of a microfluidic reactor to enhance and maintain the denitration efficiency. This work describes how to successfully enhance and maintain the denitration efficiency while using a printed three-dimensional large-flow microstructure reactor.     

Two New 4‐Hydroxyisoflavanes from the Root of Codonopsis cordifolioidea and Their Anti‐virus Activities

Two new 4‐hydroxyisoflavanes, cordifoliflavanes A and B (1 and 2), were isolated from the roots of Codonopsis cordifolioidea. Their structures were elucidated by spectroscopic methods, including extensive 1D‐ and 2D‐NMR techniques. Compounds 1 and 2 were tested for their anti‐HIV‐1 activities and anti‐tobacco mosaic virus activities. The results showed that compounds 1 and 2 have modest anti‐HIV‐1 activities and anti‐tobacco mosaic virus activities, respectively.     

匀浆提取-超高效液相色谱-串联质谱法测定烟草中亚硝胺含量

提出了超高效液相色谱-串联质谱法测定烟草中N-亚硝基降烟碱(NNN)、N-亚硝基新烟草碱(NAT)、N-亚硝基假木贼碱(NAB)和4-甲基亚硝基吡啶基丁酮(NNK)等4种亚硝胺含量的方法。烟草样品经0.1mol.L-1乙酸铵溶液匀浆提取,离心分离取上清液过Waters AcquityUPLC BEH C18色谱柱(2.1mm×100mm,1.7μm)分离,以乙腈和0.01mol.L-1乙酸铵溶液按不同体积混合作流动相梯度洗脱。串联质谱测定中采用电喷雾离子源正离子模式和多反应监测模式检测,同位素内标法定量。NNK、NNN、NAB和NAT的检出限(3s)分别为0.06,0.17,0.15,0.053μg.L-1。方法的加标回收率在92.1%～104%之间;日内和日间相对标准偏差(n=7)分别为2.7%～3.3%和3.5%～4.2%。     

cis-[（trans-1，2-双（氨甲基）环丁烷）（3-羟基-1，1-环丁烷二羧酸根）合铂（Ⅱ）]的合成和抗癌活性

通过对洛铂和卡铂的结构进行重组和优化,合成了一种新型洛铂衍生物cis-[（trans-1,2-双（氨甲基）环丁烷）（3-羟基-1,1-环丁烷二羧酸根）合铂（Ⅱ）],采用元素分析、红外光谱、质谱和核磁共振表征了其化学结构,并考察了此化合物的水溶性和稳定性。应用标准SRB法测试了目标化合物对人肺癌细胞株（NCI-H460、A549）、人乳腺癌细胞株（DU4475）、人白血病细胞株（Sup-B15）生长的抑制活性,评价了它对人肺癌细胞NCI-H460裸鼠移植瘤的治疗作用。结果表明：目标化合物水溶性好、稳定,对多种癌细胞的生长有明显的抑制活性,IC₅₀均小于10 μmol·L^-1。更重要的是,其体内对人肺癌细胞NCI-H460裸鼠移植瘤的治疗效果明显,与洛铂相当。     

有机无机杂化固态太阳能电池的研究进展

近年来, 由于钙钛矿材料优良的光学吸收和电荷传导特性, 有机无机杂化固态太阳能电池取得了突破性的进展. 自2009年首次报道了光电转换效率为3.8%的钙钛矿太阳能电池以来, 该类电池的效率不断突破. 基于介孔薄膜的电池已取得了超过16.7%的认证光电转换效率, 基于平板异质结结构电池光电转换效率达到19.3%, 已接近传统硅基太阳能电池的光电转换效率. 本文将介绍有机无机杂化钙钛矿作为光电材料的光学物理结构特性, 以及在固态太阳能电池中的应用. 基于固态钙钛矿太阳能电池结构上的差异, 分别介绍其在多孔结构、平板异质结结构、柔性结构以及无空穴传导材料结构电池工作特性和各自优势, 以及影响电池特性的主要影响因素, 特别是钙钛矿成膜控制等. 并阐述对钙钛矿电池的理解和进一步提高固态钙钛矿电池光电转换效率需要关注的重点以及展望.     

Investigation on densification of Al2O3/B4C ceramic by ab initio calculation and experiment

Compared to experiment, the adsorption energies, bonding properties, and electronic structure of two different Al₂O₃/B₄C bridge sites with seven different Al₂O₃ surfaces are investigated by ab initio periodic density functional theory. The Al₂O₃/B₄C ceramic sintered in Ar is synthesized and measured by XRD and TEM. The calculated results reveal that the densification of O_bridge site of Al₂O₃/B₄C surface is better than that of Al_bridge. The Al₂O₃ (1 1 3)/B₄C with O_bridge is the most favorable and stable. The electronic structure shows that the electron hybridization exists between Al, O atoms and C, B atoms. The results indicate that the calculated results are in good agreement with the experiment.     

烟草中多酚热裂解产物研究

多酚类化合物对烟草品质、色泽和烟气生理强度等方面有着重要影响,因此是衡量烟草质量的一个重要因素[7],对卷烟的香气品质有很重要的作用.绿原酸、芸香苷和莨菪亭是烟草中最主要的酚类物质[7],有证据表明酚类物质的存在能显著提高多环芳烃的致癌活性[1,6].卷烟主流烟气中酚类物质的含量的多少直接影响到卷烟的安全性.另外某些酚类物质可能是影响卷烟的口感,引起涩味、辣味、余味不干净的一种因素.研究它们的裂解产物对探索降低卷烟烟气有害成分,提高卷烟的吸食品质十分必要[2,5].     

Comparison of Different Cartridges of Solid Phase Extraction for Determination of Polyphenols in Tobacco by UPLC/MS/MS and Multivariate Analysis

The comparison of solid phase extraction(SPE) for the preconcentration and isolation of polyphenols in tobacco samples was carried out by ultra-high performance liquid chromatography/tandem mass spectrometry (UPLC/MS/MS) and multivariate analysis.Several adsorbing materials of SPE(C18,NH2,SAX and OASIS) were investigated.It was found that the C18 and OASIS cartridges can not only speed up the purification process,but also simplify the SPE operation.A UPLC/MS/MS was used for the determination of polyphenols ...